Hi,
I try this way too, (usually I use select/by columns/interface) but the
result is the same. Event log browse replay with "no match" but I see the
name of interface (like N1003) when I listed all event log.
Perhaps I should say that I use NT platform.
LP
Matej
----- Original Message -----
From: "Thomas Borger" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, February 13, 2001 12:18 PM
Subject: Re: [FW1] Eventlog selection
Hi Matey,
>we upgrade FW-1 with VPN 4.0 on FW-1 with VPN 4.1 SP 2. When I check events
>in fw event log I usually select one of interfaces to view the log entries
>on this selected interface.
>This was working without any problems until upgrade. I see the interface
>names when I have full view of event log. I just cannot select view on
>selected interface. Is this a bug or my mistake?
Click with the right mousbutton on the Interface-column and then use
"selection"
There you can select wich interface you want to view and whether inbound or
outbound!
regards
Thomas
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
