Hi,
I'm installing the Stonebeat HA version 3.1 and I have the following
configuration:
Hardware:
2 Sun Servers 220R with 1 Quad cards. I use qfe0 - qfe1 to connect to our
network segments through the switches and use a cross over UTP cable to
connect the hme0 network cards together. I also use serial link between the
two Firewalls or heartbeat. The external interfaces qfe0 and qfe1 have the
same IP and MAC address on both nodes.
Software:
Solaris 2.6
CheckPoint FW-1 V4.1
StoneBeat V3.1
Problem:
When I mannualy switch from PRIMARY to SECONDARY, connectivity is lost. But
if I do a SNOOP on the interfaces before the switch everything is OK.
The same applies if I want to get back to PRIMARY from SECONDARY.
Is this a Stonebeat or an interface problem?
Have anybody saw something like this? Does it make any sense?
Rodrigo
_____________________________________________________
Rodrigo Borges
TAC Support, IC ICS IP&A
SIEMENS SA, Information & Communications
Phone: +351 21 4242220
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
