Sorry, all my fault... the qfe card didnt sit properly in the slot... when I tightened up the screw on the backplane, it pulled one end down and the other end up and out of the slot. I removed the screw, pushed it back in again and its all working fine...
Memo to Self: Must look at the REALLY obvious solutions first.... Steve ----- Original Message ----- From: "John Heindl/Markham/Contr/AT&T/IJV" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, November 27, 2001 1:21 PM Subject: Re: [FW-1] Sol 7 and qfe - missing!! > Steve, > > Have you tried to plumb teh interface? > > ifconfig qfe0 plumb > > regards, > > John Heindl > IT Specialist > AT&T Global Network Services, Canada > TEL: (905) 762-7431 > FAX: (905) 762-7497 > EMAIL: [EMAIL PROTECTED] > > =============================================== > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > =============================================== > =============================================== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ===============================================