You need to set the jumper block...it's the blue, white or other-colored plastic bit under the tape that says to not remove or it will void your warranty. Settings can be found at accelerate your mac, and/or I think through OWC's site macsales.com
If you use tweezers, you can shift the jumpers in the block around to the needed positions, instead of buying new jumpers to put on the pins. > From: Colin Hoogeboom <[EMAIL PROTECTED]> > Reply-To: <[EMAIL PROTECTED]> (G-List) > Date: Wed, 13 Nov 2002 16:02:56 -0500 > To: <[EMAIL PROTECTED]> (G-List) > Subject: G3 ZIF > > I just installed a upgrade ZIP (350 MHz from OWC) for my G3 which was > running at 267 MHz per ASP. After the upgrade, ASP still shows it at 267 > MHz. Is this expected? I don't think it is, but since I have never > upgraded a ZIF before..... I hit the CUDA twice after installing the new > ZIF. Anything else I should have done? TIA -- G-List is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> G-List list info: <http://lowendmac.com/lists/g-list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:g-list@;mail.maclaunch.com> To unsubscribe, email: <mailto:g-list-off@;mail.maclaunch.com> For digest mode, email: <mailto:g-list-digest@;mail.maclaunch.com> Subscription questions: <mailto:listmom@;lemlists.com> Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
