On Oct 9, 2005, at 7:04 PM, PJ Bearstein wrote:
On Oct 9, 2005, at 5:12 PM, [EMAIL PROTECTED] wrote:
I have two drives for a Sawtooth. The second drive has OS X
installed and the
profiler lists the unit number as 0. The other has OS 9.2 and it
says the ID
is 0. These will not work together. How can I get them to work
together.
Bailey
OS X will not boot from a slave drive
Where did you get that idea? It was true for beige G3s, unless using
XPostFacto, but Sawtooths are not hampered in that way.
If jumpered as master and slave and on the same ribbon cable, make
sure the slave drive is connected to the middle connector.
, so make sure the OS X drive is set to master (drive 0) and the OS
9 drive is set to slave (drive 1) The settings "M," "S," and "CS"
are usually marked by the jumper pins. Don't use "CS" unless you
have a cable select ribbon or if your motherboard does not support it.
Regards,
Wayne Clodfelter
[EMAIL PROTECTED]
--
G-List is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished Drives |
-- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
G-List list info: <http://lowendmac.com/lists/g-list.shtml>
--> AOL users, remove "mailto:";
Send list messages to: <mailto:[email protected]>
To unsubscribe, email: <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/>
iPod Accessories for Less
at 1-800-iPOD.COM
Fast Delivery, Low Price, Good Deal
www.1800ipod.com
