Hello all, Am trying to clone my laptop's hard drive before switching it for a new hard drive. The laptop hard drive is SATA, and I have no other computer with a SATA bus, so G4U is the only possible way for me to clone the hard drive. G4U boots just fine, finds the network card just fine:
"wm0 at pci2 dev 0 function 0: Intel i82573L Gigabit Ethernet, rev. 0" Typing ifconfig wm0 gets: (am typing some of it only) <snip> media: Ethernet autoselect (100BaseTX full- duplex,flowcontrol,rxpause,txpause) status: active inet 0.0.0.0 netmask 0xff000000 broadcast 255.255.255.255 I have a DHCP server on my router and I know this works fine as my laptop has Ubuntu on, and after booting, it gets an IP address from the router and works perfect. G4U keep sending DHCP requests and keep getting "send_packet: Input/output error". I tried manually entering the IP address and ifconfig wm0 confirms the change: inet 192.168.1.3 netmask 0xffffff00 broadcast 192.168.1.255 but still no good. I also tried "route add default 192.168.1.1." but again, no good either. I did try 2.4alpha4 but got: wpi0: could not read firmware file uvm_fault(0xcdb67774, 0, 1) -> 0xe fatal page fault in supervisor mode <snip> The operating system has halted. Please press any key to reboot. Tried it without ACPI or SMP but same problem. Any ideas? I'm desperate for the bigger hard drive, and there is a LOT of work to reinstall the operating systems! Thanks very much for your time in advance! Regards - Piers ------------------------------------------------------------------------------ Come build with us! The BlackBerry(R) Developer Conference in SF, CA is the only developer event you need to attend this year. Jumpstart your developing skills, take BlackBerry mobile applications to market and stay ahead of the curve. Join us from November 9 - 12, 2009. Register now! http://p.sf.net/sfu/devconference _______________________________________________ g4u-help mailing list g4u-help@feyrer.de https://lists.sourceforge.net/lists/listinfo/g4u-help
