Whit, Oh yes, for me too. I should have pointed that out, that I compiled from source quite successfully - and my installation is working quite well - Or, working on the master, but the nodes are a different problem. See earlier post...
Kind Regards, deb ツ On Tue, 22 Jun 2010 15:45:18 -0400, Whit Blauvelt wrote: > Deb, > > Can't speak to the RPM, but simply building 3.1.7 from tar on 5.5 worked for > me with: > > libconfuse.x86_64 2.6-2.el5.rf > libconfuse-devel.x86_64 2.6-2.el5.rf > > Note the "x86_64" part. Obviously you want an i386 RPM, so this isn't your > solution. Just hoping contrasting the results might provide a clue. Perhaps > you need the i386 version of the libs installed too? > > Best, > Whit > > > On Tue, Jun 22, 2010 at 12:16:47PM -0700, Deb Heller-Evans wrote: >> Running rpmbuild per the ganglia.spec file: >> >> # rpmbuild -ta --target noarch,i386 ganglia-3.1.7.tar.gz >> >> It was running along swimmingly until it seemed to trip >> over libconfuse. I have >> >> libconfuse-2.6-2.el5.rf >> libconfuse-devel-2.6-2.el5.rf >> >> installed on CentOS 2.6.18-194.3.1.el5 x86_64. Here's the error: >> >> Checking for confuse >> checking for cfg_parse in -lconfuse... no >> Trying harder including gettext >> checking for cfg_parse in -lconfuse... no >> Trying harder including iconv >> checking for cfg_parse in -lconfuse... no >> libconfuse not found >> + make >> make: *** No targets specified and no makefile found. Stop. >> error: Bad exit status from /var/tmp/rpm-tmp.59577 (%build) >> >> RPM build errors: >> Bad exit status from /var/tmp/rpm-tmp.59577 (%build) >> ------------------------------------------------------------------------------ ThinkGeek and WIRED's GeekDad team up for the Ultimate GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the lucky parental unit. See the prize list and enter to win: http://p.sf.net/sfu/thinkgeek-promo _______________________________________________ Ganglia-general mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ganglia-general
