Jim:
Drill a hole. That's right, a hole. About 1/4 inch should do.
Put it a few inches up on that pipe extension (from the joint you added
that section to)
If that doesn't solve it, put a bolt or rod in that hole, across the gas
path. That should do it.
If you don't care for a hole, try adding a bend at the top of the tube,
say 45 degrees full diameter.
The trick is to modify the modulation frequency of the gasses passing
out of the pipe.
But you already know that.
Best,
Wayne
On 2/16/2011 2:11 AM, jim mason wrote:
any ideas out there for how to make a pulse jet robustly not work?
we're having lots of problems with thermoacoustics now that we've put
a tall stack on our gasifier swirl burner. we're using a tall stack
now to keep startup gasses away from the operator. the swirl burner
is 5" in diameter, 10" tall. we've added a 4 foot or so stack of the
same 5" diameter. it looks like this
http://www.gekgasifier.com/forums/showthread.php?t=501 (though this
one without the joint at 10")
when run under high load, it howls rather loudly. if art, it would be
fabulous. if a genset, not so good.
any other ideas or experience for how to make your pulse jet not work
under any circumstance?
jim
_______________________________________________
Gasification mailing list
to Send a Message to the list, use the email address
[email protected]
to UNSUBSCRIBE or Change your List Settings use the web page
http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org
for more Gasifiers, News and Information see our web site:
http://gasifiers.bioenergylists.org/
