Toby, I aggree with you, the only reason for the electronic version was the cost of the re-machine of a sutable "plug" of steel to replace the pump with, as to mount the distributor in.
Greg On Sat, Aug 13, 2011 at 5:22 PM, Toby Seiler <[email protected]> wrote: > GF and Greg, > > Is the gear on the pump useable to make a distributor turn? It would not > be some odd gear ratio since it controls timing of the injectors. Hopefully > a 2/1 ratio. > > A point to CDI conversion of my Mitsubishi fork lift engine (4 cyl) cost > around $80. Why not take a 4 cylinder distributor and adapt it to fit where > the gear driven injector pump is located. I'll bet you could even use the > pump gear if you can get placement right, which is most likely in the center > as opposed to offset. > > Regards, > > Toby > Seilertechco > > _______________________________________________ > Gasification mailing list > > to Send a Message to the list, use the email address > [email protected] > > to UNSUBSCRIBE or Change your List Settings use the web page > > http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org > > for more Gasifiers, News and Information see our web site: > http://gasifiers.bioenergylists.org/ > > -- Regards, Greg Manning, Brandon, Manitoba, Canada
_______________________________________________ Gasification mailing list to Send a Message to the list, use the email address [email protected] to UNSUBSCRIBE or Change your List Settings use the web page http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org for more Gasifiers, News and Information see our web site: http://gasifiers.bioenergylists.org/
