Thanks Mark, I was looking at this JD hammer mill:
<http://www.ebay.com/itm/JOHN-DEERE-HAMMERMILL-CASE-BAGGER-ATTACHMENT-/110732088998?pt=LH_DefaultDomain_0&hash=item19c82596a6> Jeff On Thu, 2011-08-25 at 21:14 -0700, Mark E. Ludlow wrote: > A small hammer mill would be fine, but you need to run it under > negative pressure to keep from making a mess. Start at the back end > with a small blower good for 12" suction. Then a fake baghouse (three > old Shopvacs in parallel would be fine.) Then, a tall skinny, cyclone > (high-efficiency) with a downleg terminated with a couple butterfly > valves operating 90deg out of phase as an airlock. This dumps into > your collection bag/drum. > > Of course, any kind of feed auger makes things more fun. Get a fine > screen for the mill and don't push things to prevent a conflagration > which would ruin anyone's day. The cyclone is about 99% efficient by > weight, so it takes the load off your "baghouse". > > An even simpler solution is a homebrew ball or rod mill. > > Mark _______________________________________________ Gasification mailing list to Send a Message to the list, use the email address [email protected] to UNSUBSCRIBE or Change your List Settings use the web page http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org for more Gasifiers, News and Information see our web site: http://gasifiers.bioenergylists.org/
