Hello all,
Long time reader, first time poster.
I am planning on building a small gasifier to run an IC engine for electricity
and heat.About 3/4 of my available energy is in the form of chipped forest
waste and the balance is waste oil. If possible I would like to add the waste
oil to a downdraft gasifier for drying and cracking.Has this been tried and
were the results favorable or would I be wasting my time.My thought was to
control oil flow by utilizing a vacuum pump from the engine. Obviously I could
use the waste oil in a separate burner, but that would seem to be unnecessary,
perhaps not.Any thoughts would be greatly appreciated. edge
_______________________________________________
Gasification mailing list
to Send a Message to the list, use the email address
[email protected]
to UNSUBSCRIBE or Change your List Settings use the web page
http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org
for more Gasifiers, News and Information see our web site:
http://gasifiers.bioenergylists.org/
