Mr. Williams

The question was from me and reflects my limited knowledge of gasification, not 
the company's.

I did not ask about digester gas being used to generate power, nor am I aware 
of digester gas being referred to as syngas, as your statement implies.  
Apparently I should have stated that the feed stock to the gasifier was 
thermally dried biosolids.

What I asked and what was answered is in point 3 below.  I am not aware of 
syngas from a gasifier, with municipal biosolids as the feedstock, directly 
fueling a CHP and was asking if it has been done.

Thank you,
Philip Pedros




Philip B. Pedros, Ph.D., P.E., BCEE
Technical Lead II
AECOM
250 Apollo Drive
Chelmsford, MA 01824
C: 781 258-8829
[email protected]<mailto:[email protected]>

From: Gasification [mailto:[email protected]] On 
Behalf Of Doug
Sent: Saturday, September 22, 2018 4:25 PM
To: [email protected]
Subject: Re: [Gasification] Question from Philip Pedros


Hi Philip,

Your question is really in several parts:

1. If you are referring to waste water containing sewage sludge, then yes you 
will have the gas present.

2. Untreated Sewage gas (to clarify which syngas you are talking about) cannot 
be fed directly into engines without at least a scrubber between the gasometer 
storage and engine.

3. The gas calorific value of 120-150 Btu/scf is perfectly adequate to run an 
engine and does not need boosting.

4. The technology you seek is already employed at many City Sewage plants, 
generating power to run the plant.

5. I suggest you find working installations, there must be quite a few in the 
USA.

Can I ask you why you or your organization think this is by your question, 
unknown technology?

Regards,

Doug Williams.

On 23/09/18 07:49, [email protected]<mailto:[email protected]> wrote:
Can untreated syngas generated from municipal wastewater sludge be used 
directly to generate power?  It is my understanding that the heating value of 
untreated syngas (120 - 150 But/scf), is too low to feed directly to engines 
and that some type of post treatment to boost the heating value to 190 -200 is 
typically economically prohibitive.   Any information on such post treatment 
and an case studies were this has been done would be appreciated.

Thank you,
Philip Pedros



Philip B. Pedros, Ph.D., P.E., BCEE
Technical Lead II
AECOM
250 Apollo Drive
Chelmsford, MA 01824
C: 781 258-8829
[email protected]<mailto:[email protected]>


_______________________________________________
Gasification mailing list

to Send a Message to the list, use the email address
[email protected]

to UNSUBSCRIBE or Change your List Settings use the web page
http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org

for more Gasifiers,  News and Information see our web site:
http://gasifiers.bioenergylists.org/

Reply via email to