Hi, I recently downloaded gnatbox light 3.0.3 installed it on my little network here at home, but can't seem to get it to work.
Here's the setup: I have gnat box running on a Pentium machine with a Linksys LNE2000 10Mb eithernet card and a internal modem sitting on com1 All the protected mode stuff works. i.e. from the gnat box I can ping my other clients, the web interface works! I want the gnat box to connect to my ISP via the 56K modem on com1 The modem is not a WinModem, if I go to a DOS prompt I can have it dial by piping commands to the com port! For some reason I can't get it to dial out. also I get a couple of errors on the message screen. 1. FILTER: Remote access filter blocks: UDP ed1 [192.0.0.254/53]->[192.0.0.1/1027] l=24. 192.0.0.254 is a machine trying to ping out the the Internet....192.0.0.1 is the gnat box. According to the documentation all outbound traffic should be allowed. At least I think, I did see something about adding a remote access filter, but the documentation was a bit vauge. 2. PPP: Warning: Add route failed: default alredy exists. Now, I think this comes from the default route setting, and I'm not sure what I'm supposed to put in there. I want the gnat box to connect to my ISP, and I need to get DHCP'd from them, after the DHCP the machine (gnat) should have it's default route...correct? So what do I put in there????? Again the documentation was a bit vauge. Thanks much, James J. Hamelic Network Engineer Medina County ESC
