Casper, I'm not sure to have understood if you have this problem while reading or generating compressed files. Could you provide a way (that is to say provide both the input data and the command line used) of reproducing this ?
Best regards, Even > Hi > > When batch processing GeoTIFF files, I tend to get this problem a bit too > often: > > Warning 1: LZWDecode:LZWDecode: Strip 11 not terminated with EOI code > ERROR 1: LZWDecode:Not enough data at scanline 11 (short 30 bytes) > ERROR 1: TIFFReadEncodedStrip() failed. > > band 1: IReadBlock failed at X offset 0, Y offset 11 > ERROR 1: GetBlockRef failed at X block offset 0, Y block offset 11 > > The strip, scanline and offsets vary. It normally happens when I process from > clients (computers) with the files located on servers (on local network), and > I can reprocess a file again without getting the error, or possible an error > with a different strip, scanline or offset. This special case is caused by > gdaldem.exe and the error is reported by gdal_translate.exe using GDAL 1.9, > but I have experienced this error using GDAL 1.9.2 and I think I saw it using > GDAL 1.10 also. > > I have two issues here: > > 1. Why the problem is happening to begin with? > > 2. Why does the Warning and/or Error not trigger ERRORLEVEL 1? > > The first bullet I think can be very difficult to debug, so I seek > experiences here. The second bullet is really frustrating, because I have to > look through all my clients looking for output similar to the message above - > and then reprocess all crashed files again. > > One solution I have seen somewhere is to not compressing the files, but this > results in quite an increase in disk space usage - way too high for me. > > > Kind regards, Casper > _______________________________________________ gdal-dev mailing list [email protected] http://lists.osgeo.org/mailman/listinfo/gdal-dev
