Hi Dan and all, And after being called in for having dinner, and putting the kids to bed, I ran ./pcbtest and didn't get the message: "Share installation path is...".
Kind regards, Bert Timmerman. -----Oorspronkelijk bericht----- Van: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Namens Bert Timmerman Verzonden: zaterdag 20 januari 2007 18:14 Aan: 'gEDA developer mailing list' Onderwerp: RE: gEDA-dev: pcb/cygwin Hi Dan, I did a fresh check out of pcb. ./configure ran without any problems. make did the usual things and I went to make a fresh cup of coffee (or two) when I saw it hitting the pcblib-newlib script. On a P4 3GHz 1Gb and 80GB available disk space it took about 68 minutes to build, andit stumbled on the puller.png (I forgot the maintainer mode again ;-). Now for people with older hardware this is certain a job to run at night, while you're sleeping. I noticed a couple of things on which I would like to make some remarks. 1) I think now is the time to reconsider "light versus heavy footprints", by this I mean: should all values of the 0.25W resistors be available as heavy footprints ? 2) Some, but not all, footprints seem to have tabs between parameters in the pin/pad definitions, for instance: all amphenol footprints. 3) the amp and bourns footprints (and maybe others I didn't check) have a lot of comment lines in the beginning of the footprint file, and also between the lines. 4) I think adding another search path for newlib style footprints is not a Good Thing (TM), is there a reason for not adding the generated M4 footprints to the newlib directory. Just my EUR 0.01. Kind regards, Bert Timmerman. P.S.: Starting of now, when I reach EUR 10.00 I will donate this amount to gedaconsulting.com -----Oorspronkelijk bericht----- Van: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Namens Dan McMahill Verzonden: zaterdag 20 januari 2007 14:36 Aan: gEDA developer mailing list Onderwerp: gEDA-dev: pcb/cygwin Can someone who uses cygwin and the gtk hid (not mingw or cygwin compiling with -mno-cygwin) see if the latest pcb in cvs still builds and works correctly for them? Also when you first run pcb, do you get a message about "Share installation path is..."? Thanks -Dan _______________________________________________ geda-dev mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev _______________________________________________ geda-dev mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev _______________________________________________ geda-dev mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev
