Re-ran autogen.sh, all is well. I seee I should have done make reconfig first.
Andlinux Ubuntu 2.6.22.18-co-0.7.3 on Win XP (thru colinux) So I found that the versions of most programs are unreported by foo --version. Programs reporting --version: gsch2pcb 1.6, gschupdate 0.2, gsymupdate 0.2. Programs which do not currently support --version: gsymcheck, gschem, gnetlist, gattrib, garchive, Running gschem, I see the old version comes up just fine, 20070626, with untitled.sch. Running ./gschem in geda/bin, I see 1.4.0.20080127 opens up with nothing, no menus, no toolbars, no schematic. So I copied /usr/share/geda/scheme to /usr/local/share/geda/scheme, and reopened ./gschem, and got toolbars. No menus, though, and no schematic. Now what? Thanks much Ross Amans Hardware Design Engineer Biometric Access Co 512-426-9252 (cell) -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Peter Clifton Sent: Friday, May 30, 2008 7:09 PM To: gEDA developer mailing list Cc: [EMAIL PROTECTED] Subject: Re: gEDA-dev: latest On Fri, 2008-05-30 at 16:00 -0500, Amans,Ross wrote: > When make install on geda 1.4.0, I get the following error: > > > > make[2]: Entering directory `/root/temp/libgeda-1.4.0/po' > > make[2]: *** No rule to make target `Makevars', needed by `Makefile'. > Stop. > > make[2]: Leaving directory `/root/temp/libgeda-1.4.0/po' > > make[1]: *** [all-recursive] Error 1 > > make[1]: Leaving directory `/root/temp/libgeda-1.4.0' > > make: *** [all] Error 2 > > > > ??? Makevars ??? Did you re-run ./autogen.sh for libgeda? Take a look out for any warnings after: autogen.sh running: intltoolize ... If so, post here.. you might need to install intltool. What OS / distro is this on? -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-dev mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev _______________________________________________ geda-dev mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev
