On Wed, Nov 19, 2008 at 09:48:48PM -0800, Ben Jackson wrote:
> On Thu, Nov 20, 2008 at 12:39:51AM -0500, DJ Delorie wrote:
> >
> > I wonder if the polygon clipper is being ignorant of arcs that aren't
> > multiples of 90 degrees?
>
> That doesn't seem to be the case. I've run into problems like this before
> when line endpoints overlap. I've also seen it caused by one straight
> line being made of two segments (normally impossible because the drawing
> code won't create them).
I get them very often. They disappear when selecting the line and
putting it back at the same place, at least when the grid is in
inches. On a metric grid, the end points are too often off by an
underlying grid unit and the only solution is to delete and redraw.
BTW, this is one of the strongest arguments to switch to an
underlying metric grid.
Regards,
Gabriel
_______________________________________________
geda-dev mailing list
geda-dev@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev
