Tamas - On Fri, Jul 14, 2006 at 09:41:38PM +0300, Tamas Varga wrote: > > I didn't check it before, but bug 2 is not present on my gtk build > > that includes my second patch (Thu, 13 Jul 2006 19:36:26 -0700). > > I checked again with the latest version I could get today from CVS. When I'm > on the solder side and I move a part designator (which is temporarily > replaced with a rectangle during the move) then I still get the same > incorrect rectange graphic as in case 1.
The CVS committers don't sit around waiting to apply each patch as I post it. :-( And of course if they did, they'd also have to revert those changes about half the time. Double :-( Assuming you use the gtk gui, grab my patch from http://archives.seul.org/geda/dev/Jul-2006/msg00058.html > The auto pan is toggled with the right mouse button. It's described in the > key reference (under the Window menu): while drawing or moving, a click > without a drag toggles auto pan mode. Cool. That helps a lot. > 4. When on the solder side the grid only appears in a vertical band at the > middle of the board. The width of this band is the same as the visible width > of the board at the current zoom level. Probably there is a sign inversion > problem with the X coordinate somewhere, as when scrolling instead of the > band following the visible board area it seems to move in the opposite X > direction. I noticed that too. I'll add it to my to-do list. - Larry _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
