On Sunday 29 October 2006 12:48, Stefan Salewski wrote: > what is the best way to handle "solder bridges" (Lötbrücken in > german) in gschem and pcb.
Small Zero Ohm resistors. > These connections can be removed easlly by removing this > drop using a clean hot soldering iron. This allows to use a > device in different modes. Depending on how many, and how complex the (re)configuration maybe, it is usually more expedient to use the Zero Ohm resistors. With a good solder mask it can be hard to get the pads to bridge, and you spent more on labor time than you would have on the resistor. -- http://www.softwaresafety.net/ http://www.designer-iii.com/ http://www.unusualresearch.com/ _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
