sure. And I did the "disperse all elements" too.
2006/11/7, Dan McMahill <[EMAIL PROTECTED]>:
Giorgenes Gelatti wrote: > > 2006/11/6, John Luciani <[EMAIL PROTECTED]>: > >> On 11/6/06, Giorgenes Gelatti <[EMAIL PROTECTED]> wrote: >> > I got a simpler circuit that is not working. >> > I have snap turned on, but can't see a way of making it works :( >> > >> >> What specifically isn't working? >> >> the netlist produced --- >> >> unnamed_net9 serial-2 pinbar-9 >> unnamed_net8 serial-1 pinbar-10 >> unnamed_net7 serial-4 pinbar-7 >> unnamed_net6 serial-6 pinbar-5 >> unnamed_net5 serial-8 pinbar-3 >> unnamed_net4 serial-3 pinbar-8 >> unnamed_net3 serial-5 pinbar-6 >> unnamed_net2 serial-7 pinbar-4 >> unnamed_net1 serial-9 pinbar-2 >> >> which is all of the connections. I do not have the same set of >> footprints so I >> did not check out a PCB file. >> >> (* jcl *) > In pcb the components are not connected. :-( Did you open the .pcb file and then load the netlist and then press 'o' (optimize rats)? -Dan _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
