DJ
I think you've explained the behavior I've viewed as a bug. The pin
numbering code should allow narrow lines for readability while you are
editing - this is good. However, the silkscreen text must be drawn with
accurate width in the editor so that it can be placed to prevent their
landing on pads etc. Allowing it to be artificially thin can get you in
trouble.
Joe T
DJ Delorie wrote:
Could anyone tell me what is going on?
The gerbers and PS output honor the "minimum silk thickness" DRC
setting. The GUI doesn't. The reason it's not fixed is because the
same code does the pinout numbers, and if you make them thick enough
they're just blobs.
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
