On Mar 10, 2007, at 6:41 PM, Matthew Sager wrote:
I have been working on a program to convert Gerbers to gcode. So
far it is
not completely working. It should output a good gcode file for
drilling the
vias as long as you have drill bits for all the via sizes that you
used on
the PCB. Parsing out the trace edges is still a work in progress.
I am
trying to clean up the code some and support rectangular pads right
now. It
might work ok for a very simple PCB, but most likely you would have
to do a
lot of editing by hand to fix the problems.
Why use gerbers for the drill locations? Use the excellon NC drill
file instead.
-a
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
