On 8/21/07, James Moody <[EMAIL PROTECTED]> wrote: > John Luciani wrote: > > On 8/21/07, James Moody <[EMAIL PROTECTED]> wrote: > > > >> Question 1: > >> > >> Regarding those "structural" pads I asked about yesterday (by the way, > >> thanks for all of the great answers!), a Molex surface mount connector > >> I'm using recommends L-shaped solder pads to anchor the connector to the > >> board. Visualize this as a square divided into quadrants, and one of > >> them removed. > >> > > > > To create an L-shape structural pad just overlay two rectangular pads. > > > OK, so for these two overlapping entries, Clearance should be zero, and > the Mask should be (at least) the full width of the pads?
I have been keeping the clearance and mask parameters for the pads the same whether they overlay or not. (* jcl *) -- http://www.luciani.org _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
