-----Original Message----- From: Peter Clifton [mailto:[EMAIL PROTECTED] Sent: Thursday, December 13, 2007 11:04 AM To: [EMAIL PROTECTED]; gEDA user mailing list Subject: Re: gEDA-user: gerbv
On Thu, 2007-12-13 at 10:20 -0500, Ian Chapman wrote: > I have noticed a minor difference between gerbv under Linux and Viewmate 9.8 > under XP. The unplated-drill.cnc loads and displays under Linux but under > XP gives ---Warning - syntax error M4BINC?H,TZT12C0.170%*. I have pasted > the unplated drill file on the tail of this post. I wonder if you need windows line-feeds (\r\n) rather than Unix (\n) for feeding the Viewmate program? Try running the output through the unix2dos command (apt-get install tofrodos) I'll give it a try tonight. The silkscreen and all other files load on both applications. It is only the drill stuff that fails on the XP system. The fab people are happy with the gEDA files. I'll report on the board once I see it. Regards Ian. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
