Hi DJ, Your tutorial looks very good indeed.
Following notes are not criticism, just a slightly different "modus operandi". FWIW, the boards I layout contain a bit more parts/footprints. When routing these w/o netlist (and thus w/o ratlines) I name the parts with their refdes first and then route the necessary traces. When the number of pins on a part is large or the numbering scheme is confusing (example: DSUB connector), I use the pinout window. Furthermore when I'm just a little bit certain a named part is in the *right* position I lock it. Just my EUR 0.02 Kind regards, Bert Timmerman. On Wed, 2007-12-26 at 18:13 -0500, DJ Delorie wrote: > > First board: two-pin jumper, resistor, LED. All stock symbols and > > footprints, single layer board, no vias. > > This one is done, pending feedback. Enjoy! > > http://www.delorie.com/pcb/docs/gs/ > > LOTS of pictures. 43 at the moment, just for that first board. > > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
