DJ, I went through the design and got it to pass all the drcs.
run drc get No DRC problems found. optimize rats get 590 rat lines remaining autoroute all rats nests get The rats nest is stale! Aborting autoroute... try 1) using layers component, signal1 and solder try 2) using layers component, signal1, solder, gnd, power1, power2 both trials give up with the stale rats nest message. I am going to make a copy of the design file as it is now and set it aside so that if Anthony wishes to take a look at getting it autorouted that he can. For now, I am going to start hand routing 590 rat lines. Thanks for the suggestions/advice, Steve Meier On Thu, 2008-05-01 at 16:32 -0400, DJ Delorie wrote: > Ok, some stupid things to check: > > Your current route style meets your DRC requirements. > > The layers you want to route on are visible; all others are off. > > Maybe we should get Anthony to look into this, as part of his learning > experience? _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
