I'm using gschem 1.4.0 and get a consistent segmentation fault when moving a group of parts. I tar'd the whole thing up, you can retrieve it at http://www.geocities.com/fazool1_2000/geda/ggSegFault.tar.gz
If you look at this picture: http://www.geocities.com/fazool1_2000/geda/b4_fault.png I've highlighted the stuff that I wanted to move. Try to move the group so that the net from the 2nd opamp from the top, non-inverting terminal, is a straight line to DAC pin 25. It bombs every time. I can move the group just about anywhere else, and it's ok. I discovered that if I move the group down below the opamp, set in place, then move the group up again so that straight line is the way I wanted, there's no seg fault. Sorry for the lousy graphics in the png. regards, gene _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
