> Today's Topics: > > 1. how to check for holes and pad size (Vincent Onelli) > 2. Re: how to check for holes and pad size (DJ Delorie) > > > ---------------------------------------------------------------------- > > Message: 1 > Date: Mon, 04 Aug 2008 09:29:46 -0400 > From: Vincent Onelli <[EMAIL PROTECTED]> > Subject: gEDA-user: how to check for holes and pad size > To: [email protected] > Message-ID: <[EMAIL PROTECTED]> > Content-Type: text/plain > > Hi, > Is there a way to find out what size the holes and the pads are? I was > not able to find that information any ware. > thank you. > Vinny > > > > ------------------------------ > > Message: 2 > Date: Mon, 4 Aug 2008 09:39:03 -0400 > From: DJ Delorie <[EMAIL PROTECTED]> > Subject: Re: gEDA-user: how to check for holes and pad size > To: [email protected] > Message-ID: <[EMAIL PROTECTED]> > > > Put the crosshair over the pin/hole and hit Ctrl-R to report on that > pin/hole. > Thank you so much for the quick answer,
Here, I have an other question, PCB does not have circle command how can the semicircle be constructed and wind up with open to one the side rater than diagonal. I am try to make the TO92 footprint there is one in the library but the pin are too close together. I will appreciate the help. Vinny P.S. I think that the addition of circle command would be very useful. > > ------------------------------ > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > > > End of geda-user Digest, Vol 27, Issue 5 > **************************************** _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
