> Pin[0 0 13000 2000 13600 11811 "" "1" "edge2"] > Pad[-11811 0 -9842 0 4000 5600 9600 "2" "2" "square"] > Pad[9843 0 11811 0 4000 2000 6000 "1" "1" "square,edge2"]
> From this aren't the pads inside, or on, the hole created by the pin? Nope. There's about 13 mil clearance. Try bringing it up in PCB and see for yourself. > Wouldn't the annular short the pads? How I read this is, you have a 6 > mil thick annular with an inside diameter of 130 mils. 130 mil *copper* (outside) diameter, 118.11 mil drill. It's 156 mils between the two pads, so (156-130)/2 = 13 mil gap. > Also, the way I understand the mask isn't the mask inside the annular? 136 mil mask, 130 mil copper. That leaves 3 mil between the two. _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
