I'm all set. I just got them from gedasymbols.org Thanks
On Sun, Aug 17, 2008 at 6:47 PM, Stuart Brorson <[EMAIL PROTECTED]> wrote: > I seem to recall that M4 gets stuck on footprint names with a - in > them. Try TO18 or TO_18. > > Stuart > > > On Sun, 17 Aug 2008, Robert Butts wrote: > > > I think the problem is in the footprints. For to TO-18 I wrote TO-18 and > > I'm thinking gsch2pcb is getting stuck there. > > > > On Sun, Aug 17, 2008 at 6:25 PM, <[EMAIL PROTECTED]> wrote: > > > >>> I'm trying to run a very simple schematic thru gsch2pcb and it's > getting > >>> stuck. The printout says: using the m4 processor for pcb footprints > >> > >> Are you using newlib (file type) or M4 footprints? I rename the > directory > >> for the M4 stuff and only use newlib footprints that I create. > >> > >> Does gsch2pcb stop at a point and tell you the results of it's job? > >> > >>> Aside > >>> from that it's just a thru hole definition. Any ideas? > >> > >> This shouldn't make any difference. > >> > >> Phil > >> > >> > >> > >> _______________________________________________ > >> geda-user mailing list > >> [email protected] > >> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > >> > > > > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user >
_______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
