On Mon, 2008-09-08 at 19:41 +0200, Levente Kovacs wrote: > Hi, > > > I created a symbol with two attributes attached. When I place that > symbol on my schematic, only one of them is listed in the attribute > editor (with the ee command). > > How can I make gschem to copy all attributes along the symbol as it > places it?
Only certain invisible attributes are promoted. This list is in the gafrc file, for example, my system-gafrc: ; always-promote-attributes ; ; Set the list of attributes that are always promoted regardless of ; their visibility. ; (always-promote-attributes "footprint device value model-name") I haven't got the code up right now, and can't quite remember, but I think all visible floating attributes are promoted by default. Only the invisible ones listed in the above directive are promoted unless you enable the following: ; promote-invisible string ; ; If attribute-promotion is enabled, then this controls if invisible floating ; attributes are promoted (attached to the outside of the component) if the ; text string is invisible. There are cases where it is undesirable, so the ; default is disabled. ; ;(promote-invisible "enabled") (promote-invisible "disabled") Best wishes, -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
