At 11:19 AM 9/26/2008, you wrote:
On Tue, 16 Sep 2008 22:40:03 -0400
Rick Collins <[EMAIL PROTECTED]> wrote:
> I have scanned this thread, but other than the first post, I am not
> clear on the goal of your efforts. If you are really just trying to
> "panelize" boards into a step and repeat pattern, there is an easier
> way to do it. The RS-247X Gerber format has a step and repeat
> command that will allow you to easily indicate your panel
> specs. Layout the board once, and then add the step and repeat
> command to indicate the X and Y spacing of the boards. This does not
> cover the drill file, but that is easily extended by repeating the
> drill instructions with the X and Y values incremented appropriately.
>
> Is there a need to generate the entire panel in the layout
> program? With a little effort, the panel could be viewed without
> actually duplicating all of the tracks and components. Then other
> items could be added to the panel such as global fiducials.
You can add fiducials, positioning holes, project codes, test objects, Cu
surrunding areas to the panel PCB. They are mainly used only in mass
production, but why not to do it, whet it is only a few line of perl code? ;-)
I'm not saying that anything should *not* be done. I am just saying
that there is a need for a simpler method (built into the main tool
and part of the board file) of duplicating a single design along with
fiducials as this is all that is most commonly needed for production
work. It is easy to specify the basics of X/Y board count and
spacing and where fiducials should go. Using the script is *not*
just a few lines of perl code. You have to run the script to
generate a *new* board file, so now you have two files that have to
be kept in step each time you touch the design. You also have to add
your features to the panel file each time you touch the board file.
In a production environment this is too much manual work and is
likely to result in an expensive mistake at some point. Typically
the board layout goes through design review. Then producing the
final design file set should be done with as little as possible human
touch to minimize the chance of errors being introduced.
I am looking for layout tools that are well suited for a production
environment. The lack of good panelization tools is one of the
shortcomings of FreePCB. It provides board replication by use of the
step and repeat Gerber command, but does not provide for global
fiducials. I have yet to consider PCB fully so I don't know how well
the script tool works. On the surface it would appear to have the
above issues. If the script were integrated into the tool it would
solve some of the issues.
Rick
Arius - A Signal Processing Solutions Company
Specializing in DSP and FPGA design URL http://www.arius.com
4 King Ave 301-682-7772 Voice
Frederick, MD 21701-3110
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
