On Wed, 2009-02-11 at 21:12 +0000, [email protected] wrote: > Hi Peter, > > I've been running the branch this evening and already tripped over a > rendering issue of moderate severity - one of the polygons on my board is > not being filled. > > Here's the screenshot of the HEAD build: > > http://www.muppetlabs.pwp.blueyonder.co.uk/geda/board_HEAD.png > > Note the extension of the ground fill under the two big caps top left, > then look at the render from the branch: > > http://www.muppetlabs.pwp.blueyonder.co.uk/geda/board_pcjc2.png > > That poly is not filled.
Were you viewing on the backside? I just completed a board design since I added the contour culling, and discovered that I've got it wrong for the flipped coordinate systems other than a head-on view of the board. Will fix that when I get chance. > The board file is at > > http://www.muppetlabs.pwp.blueyonder.co.uk/geda/loop_conditioner_board.pcb.gz Thanks! -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
