On Thu, 2009-04-23 at 07:09 -0600, KURT PETERS wrote: > Reference: "Compile from source: try 2" > I still can't seem to get the source code compiled... Would it help > if I review the exact procedure I used? > Here's the error message again during "sudo make install": > I can make configure, but when I make install, I get this error. Any > thoughts? > I'm not sure what olib.c is or what the error means. I did install > flex.
Try re-running "make config" after installing flex. This should re-run ./configure in the various sub-directories with the right command. This might be required to pickup the missing tool path - not sure, but can't hurt to try it. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
