On Thu, 2009-04-30 at 13:14 -0700, Lance Earl wrote: > My footprint attribute reads "Reed-Relay_Meder_DIPxx-1C90-51D" >
If this is my one -- I have replaced the footprint at gedasymbols about 10 days ago, looks better now. The old was OK, but did not fit very well. Please consider downloading again. Your problem may result from the minus sign in the footprint name, this can have special meaning for M4 macro processor. I have disabled M4 footprints on my box, because for all a newlib copy is available. But gsch2pcb uses M4 by default. To disable M4 you may put "skip-m4" in your gsch2pcb project file like ste...@amd64-x2 ~/gEDA/DAD $ cat p1 schematics FPGA_Power.sch FPGA_B0B1.sch FPGA_B2B3.sch RAM.sch ADC.sch output-name b1 skip-m4 elements-dir /usr/local/share/pcb-symbols-jcl_2008-4-25 elements-dir /home/stefan/gEDA/imported-footprints elements-dir /mnt/data/stefan/gedasymbols/www/user/stefan_salewski/footprints elements-dir /home/stefan/gEDA/custom-footprints Or you may try to rename the footprint, remove the "-". Best regards Stefan Salewski _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
