On Mon, Jun 1, 2009 at 8:35 AM, Tamas Szabo <[1][email protected]>
wrote:
Hi,
Can I make a pin without plating and put the footprint only to the
component side? If yes, how can I do it?
It sounds like you want a copper ring with an unplated hole. IIRC
pins create copper on both sides.
A square pad with rounded corners is a circle. You could try placing a
mounting hole in the center of a component side square pad with
rounded corners. The fab may not produce a clean edge on the hole.
(* jcl *)
Thanks,
/sza2
_______________________________________________
geda-user mailing list
[2][email protected]
[3]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
--
You can't create open hardware with closed EDA tools.
[4]http://www.luciani.org
References
1. mailto:[email protected]
2. mailto:[email protected]
3. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
4. http://www.luciani.org/
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
