On Sunday 23 August 2009 12:14:55 pm Stefan Petersen wrote: > Stefan Petersen wrote: > > Maybe I go out on a limb here, there is a program called pcb2gcode at > > [snip] > > > Haven't tried it though, found it three days ago and I am interested in > > a user report on it. > ... > I have now downloaded it from SVN, compiled and tested it. I have an > Ubuntu 8.10 and for obvious reasons gerbv compiles on it. ;) > ... > Anyhow, I think this pcb2gcode has potential, given some time and maybe > some helpful hands. That is at least what I think. >
I finally got SuSE 11.0 upgraded to 11.1 and now I can compile the trunk. It compiled but seqfaulted on anything but basic circles and polys. I then got the SVN updates and viola, it worked well on all my small test gerbers. I am not able to reliably get 10 mill traces and 12 mill surface mount pads yet. I've varied the offsets and smoothing flags to no avail. _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
