For two layer boards, plating the holes is the hardest part. You can get through-hole rivets, but I've never tried them. One trick is to make a two layer board, but use jumpers to connect the two sides. You just need to make extra large vias with solder pads on each side and then stick a short straight piece of wire through the hole. I've even seen high-volume manufactured boards built with this method. -Alan
On Sat, Nov 28, 2009 at 6:22 PM, DJ Delorie <[email protected]> wrote: > > Er, how are you planning on making *any* board at home, without a > laser printer? > > For two layer, just do whatever you do for one layer, but on both > sides. Pre-drill a couple of holes to help you line up the two sides. > > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
