On Jan 30, 2010, at 9:21 PM, Kai-Martin Knaak wrote: > On Sun, 31 Jan 2010 01:10:28 +0000, Phil Frost wrote: > >> Is there some way to instruct PCB to put a copper pad for through-hole >> pins only on the bottom of the board? > > No. > This is an aspect of the long standing feature request "user definable > pad-stack". >
True enough. Until then, you could do a hack by creating a footprint defining a very small annulus for the pin, and then on the back-side only put a surface pad over each hole. Some folks (me among them) do something similar to create "easy hand soldering" footprints for through-hole parts. -dave _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
