On Fri, 2010-05-28 at 01:33 -0400, DJ Delorie wrote: > I needed to do some logos, so everyone gets a logo tool :-)
[snip] > It can also be used to cut holes in a ground plane, by drawing the > hole as a separate polygon then stitching it to the plane's polygon. I'd caution against such usage, as the stitching will break proper polygon trimming and possibly connectivity scanning. (More details on geda-dev). Use for logos should be fine - although "might" cause asserts with PCB built for debugging. The stitching rather relies on a corner case of polygon support, so let us know if you encounter any bugs.. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me) _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
