Am 25.10.2010 um 13:13 schrieb Peter Clifton:
I committed a change which made everything support mixed case, but
after
some discussion, reverted it and made everything consistently case
sensitive.
Found that in the ChangeLog and promtly raised the noise level of
this list. :-/
and allow the outline to be on the solder side. The later would allow
to mill the outline on single sided boards.
Do you mean flipping the outline layer so the router is effectively
working from the underside of the board? Sounds like a potentially
useful flag. Presumably the G-code exporter already flips the solder
side.
Yes, yes and yes. It looks like it's sufficient to just not treat the
outline layer when handling isolation milling, but in a then new
feature of outline milling. If you want to mill the outline from the
front side, add "outline" to the component side group, else add it to
the solder side group.
Markus
- - - - - - - - - - - - - - - - - - -
Dipl. Ing. (FH) Markus Hitter
http://www.jump-ing.de/
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
