Am 01.11.2010 um 22:03 schrieb Matthew Sager:
if you plan to use the same size bit as the trace width and you just
want to
mill down the center of the trace.
Huh? If you mill down the center of the trace you remove the copper
there and get a negative of what you want. Did I miss something?
You would have to use a layer as a "milling" layer and then you could
draw arbitrary holes and slots. I don't know that doing this from the
gcode exporter is possible yet, but parsing it from an exported gerber
file is not to bad.
Matthew
--
My homepage.
[1]http://sites.google.com/site/matthewsager/home
References
1. http://sites.google.com/site/matthewsager/home
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
