Den 2011-01-07 14:58:59 skrev Martin Kupec <[email protected]>:
On Fri, Jan 07, 2011 at 12:06:12PM +0100, Johnny Rosenberg wrote:
So, if I decide to use a 74-power symbol after all, is there any way I
can
design it making it automatically understand where it belongs, so I
don't
need to manually enter all those ”U1, U2, U3” und so weiter?
You need to manualy assign number to that particular component.
Either you can autonumber everything and than manualy renumber
the 74-power (probably leaving holes in the numbering) or number
the 74 and 74-power when you place it with the same number
manualy and use autonumbering without the 'override' feature.
If I wanted a lot of work, I could draw my components with a pen on a
piece of paper and then scan the whole thing…
Martin Kupec
Sounds like a great source for errors. How do I prevent giving them the
wrong numbers by accident (except trying extra hard when doing the manual
job)?
--
Kind regards
Johnny Rosenberg
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
