Hi, I think there are a few persons using pcb here. So i send this message to geda-user too.
I'm using pcb 1.7.2 under RedHat 7.3 (KDE) and I've a little graphic problem. When I start pcb, it runs normally for a few moment, but then the mouse begin to have a strange behaviour : I can't select any tools, or click on menus, I only can move my design in the pcb window ! If I close and restart pcb, the mouse always have this behaviour... I have to logout, and then loggin again to restart pcb on a noral mode... My graphic card is configured to have a 1280x1024 resolution, but even if i try to switch to a smaller one (ctrl Alt +, ctrl Alt -), the mouse stays in its strange mode... do you have some idea to resolve this ???? -- Pierre Carecchio Laboratoire des Ecoulements G�ophysiques et Industriels tel : (0) 476 825 134 fax : (0) 476 825 286
