[ Ales here, I'm reposting this since majordomo didn't recognize the e-mail as being subscribed to the geda-dev/geda-user mailinglist. ]
-- Cut here -- Delivery-Date: Fri, 05 Nov 2004 20:42:29 -0500 From: Steve Meier <[EMAIL PROTECTED]> David Koski wrote: >On Fri, 5 Nov 2004 19:50:09 -0500 >DJ Delorie <[EMAIL PROTECTED]> wrote: > > > >>>Good point. I'll probably do that. But the pads are rounded (they >>>don't have to be) and I would rather have a straight edge of the >>>mask. >>> >>> >>You could put a pad lengthwise just off the edge of the board, and use >>its mask. The relief would have to be large enough to cover the whole >>edge connector. >> >> > >Will that effect the DRC or cause the vendors DRC to fail? > >David > > > If the dummy Pads demensions are large enough to pass the drc then PCB won't generate an error. Instruct the vendor to remove the dummy pad and then it won't effect them as well. Steve Meier
