> > There's a 10ohm resistor as load, I = V/R = 200/10 == 20A?(assuming DC) I'm > not sure how the diode bridge affects this, but 2A seems a little bit low > to me.
In the email you sended yesterday there is a 100 Ohm resistor: * Load resistance ROUT 4 0 100 > In interactive mode I plotted I(1) and I(2), and they varied between 0 and > 200, which is sortof what I would expect, seeing as the output is not > really DC. > > > May be the value V(1,2) is not covered by the command ".save all". > > Could you try ".save V(1,2) or may be the "define" command together > > with .control. > > .save V(1,2) just saves V(1) and V(2) into the raw plot. > I don't know how to use those define and .control things. Unfortunalty that's almost not documented. As far as I know, it's quite easy. Just take the command as used in interactive mode and put them between .control and .endc. Peter
