> I have mentioned this but it seems a good time to bring it up again.
> PCB thermal is always a cross. However, when I have a plane on only
> one side of the pin, I want the thermal to be 'V' shaped, in other
> words, I want the thermal to be only on the plane side of the pin. I
> will appreciate if this feature can be added.

I remember the request.  If it's really important to you, you might
consider adding it yourself - the thermal code isn't that tricky, but
the polygon detection is.  A similar problem exists where clearances
are tight and the thermal needs to be built with care to avoid DRC
errors.

For now, the solution is "don't do that" ;-)

Reply via email to