changeset 1252ec1c8714 in /z/repo/m5
details: http://repo.m5sim.org/m5?cmd=changeset;node=1252ec1c8714
description:
Config: Change misleading "cycle" message to say "tick".
Most of the messages in the config scripts that report a time value
already
print "@ tick" followed by the current tick value, but a few were
printing
"@ cycle". Since this is a distinction that's frequently confusing to
new
users, this changes those message to the more accurate and consistent
"@ tick".
diffstat:
configs/common/Simulation.py | 6 +++---
1 files changed, 3 insertions(+), 3 deletions(-)
diffs (30 lines):
diff -r 634d88f0dbd4 -r 1252ec1c8714 configs/common/Simulation.py
--- a/configs/common/Simulation.py Mon Nov 15 19:37:15 2010 -0800
+++ b/configs/common/Simulation.py Wed Nov 17 23:16:19 2010 -0500
@@ -246,7 +246,7 @@
else:
print "Switch at curTick count:%s" % str(10000)
exit_event = m5.simulate(10000)
- print "Switched CPUS @ cycle = %s" % (m5.curTick())
+ print "Switched CPUS @ tick %s" % (m5.curTick())
# when you change to Timing (or Atomic), you halt the system
# given as argument. When you are finished with the system
@@ -267,7 +267,7 @@
exit_event = m5.simulate()
else:
exit_event = m5.simulate(options.warmup)
- print "Switching CPUS @ cycle = %s" % (m5.curTick())
+ print "Switching CPUS @ tick %s" % (m5.curTick())
print "Simulation ends instruction count:%d" % \
(testsys.switch_cpus_1[0].max_insts_any_thread)
m5.drain(testsys)
@@ -367,7 +367,7 @@
if exit_cause == '':
exit_cause = exit_event.getCause()
- print 'Exiting @ cycle %i because %s' % (m5.curTick(), exit_cause)
+ print 'Exiting @ tick %i because %s' % (m5.curTick(), exit_cause)
if options.checkpoint_at_end:
m5.checkpoint(joinpath(cptdir, "cpt.%d"))
_______________________________________________
m5-dev mailing list
[email protected]
http://m5sim.org/mailman/listinfo/m5-dev
