You can just run SE mode by building the common .opt file and then using: ./build/X86/gem5.opt ./configs/example/se.py.
The se.py file also has been modified to support the change in the binary file.. Pritha On Sat, Feb 18, 2012 at 11:48 PM, Mahmood Naderan <[email protected]>wrote: > >there is a variable set which calls the full system mode or > >the Syscall Emulation mode. > > What is that then? How can I run simulation in X86_SE? > > On 2/18/12, Pritha Ghoshal <[email protected]> wrote: > > Hi Mehmood, > > > > You have to just run this command: > > scons build/X86/m5.debug > > > > The FS and SE modes have become run time usages rather than build time. > > Therefore the binary stays the same for both of them, whereas in the > fs.py > > file or se.py file there is a variable set which calls the full system > mode > > or the Syscall Emulation mode. > > > > Pritha > > > > > > On Sat, Feb 18, 2012 at 12:36 PM, Mahmood Naderan > > <[email protected]>wrote: > > > >> Hi > >> It seems that variables in build_opt are changed in new revisions. > >> > >> for this command: > >> scons build/X86_SE/m5.debug > >> > >> I get this error: > >> Error: cannot find variables file > >> /home/mahmood/gem5-ef8630054b5e/build/variables/X86_SE or default > >> file(s) /home/mahmood/gem5-ef8630054b5e/build_opts/X86_SE > >> > >> comparing with previous revisions, there is no X86_SE file. Instead > >> there is only a file named "x86". > >> > >> http://repo.m5sim.org/gem5/file/ef8630054b5e/build_opts > >> > >> -- > >> // Naderan *Mahmood; > >> _______________________________________________ > >> gem5-users mailing list > >> [email protected] > >> http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users > >> > > > > > -- > -- > // Naderan *Mahmood; > _______________________________________________ > gem5-users mailing list > [email protected] > http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users >
_______________________________________________ gem5-users mailing list [email protected] http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
