Hi Joonho, Did you manage to configure eth0 in X86 FS?
Regards, On 4 February 2014 10:18, 백준호 <[email protected]> wrote: > Hello, > > > > I am struggling to add a NIC card to X86 fullsystem. I did the following > thing based on the advice from the previous discussion by Fangfei and David: > > - Add the following line to makeX86System() in FSConfig.py > > self.eth0 = IGbE_e1000(pci_bus = 1, pci_dev = 0, pci_func = 0) > > self.eth0.pio = self.iobus.master > > self.eth0.config = self.iobus.master > > self.eth0.dma = self.iobus.slave > > - Change source_bus_irq in pci_dev_inta MP table entries to match > Interrupt pin number assigned to IGbE_e1000 device. > > source_bus_irq = 0 + (30 << 2) (note: IGbe_e1000 interruptPin = > 0x1e) > > > > But, I get the the following kernel error message "Can't find IRQ for PCI > INT A; probably buggy MP Table" that seems to be observed by other people. > > Do I make some other changes related to interrupt? > > > > Thanks in advance > > > > Sincerely, > > Juno > > > > > > > > > > > > > > > _______________________________________________ > gem5-users mailing list > [email protected] > http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users >
_______________________________________________ gem5-users mailing list [email protected] http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
